• Maintenance practices​ & CM​
• Principles of vibration​
• Introduction to vibration measurement​
• Introduction to the time waveform ​
• Introduction to the spectrum​
• Introduction to forcing frequencies​
• Explaining the vibration units ​
• A brief introduction to phase ​
• Data acquisition ​
• Sensors places on the machine​
• Sensor mounting and surface preparation​
• Signal processing​
• A quick tour of your analyzer​
• Spectral averaging​
• Vibration analysis​
• The spectrum analysis process​
• Diagnosing common fault conditions​
• Setting alarm limits​

You will learn about this course:

• condition monitoring, including a summary of the most common technologies
• Reliability improvement
• how vibration analysis plays a key role in reliability improvement
• How machines work via the supplementary self-study “equipment knowledge” section of the manual
• the fundamentals of vibration: waveforms, spectra, and simple metrics
• how to take dependable, repeatable, high-quality vibration readings
• Vibration sensors, and how and where to mount them
• The basics of the analysis process, primarily with vibration spectra
• The basics of the key analyzer settings: fmax, resolution, and averaging
• The basics of setting alarm limits
• The common “failure modes” of machines and how to detect them, including rolling element bearing faults, unbalance, misalignment, looseness, and resonance

• Collect vibration data
• Validate that the data is good
• Begin to perform basic analysis
• Use the training and certification as the start of a new and rewarding career as a vibration analyst

Day 1

• • Maintenance practices
  • Condition monitoring
  • Principles of vibration
  • Introduction to vibration measurement

Day 2

• • Introduction to time waveform
  • Introduction to spectrum
  • Introduction to forcing frequencies
  • Explaining the vibration units
  • A brief Introduction to phase

Day 3

• • Data acquisition
    • How do we measure vibration?
    • Sensors places on the machine
    • Understanding axial and radial readings
    • Sensor mounting and surface preparation
    • Naming conventions
    • What are “routes” and how do you create them?
  • Signal processing
  • Vibration analysis
    • The spectrum analysis process
  • What is resonance – a quick introduction
  • Diagnosing common fault conditions
  • Setting alarm limits

Accredit certification of successful completion is issued from Mobius Institute after the training.

Accredit certification according to ISO 18436 is issued from Mobius Institute after passing the ISO examination.